English
Ice cream freezer
18
Before reassembling the components, accurately wash the fixed parts of the device:
-
the extraction pipe and the safety grill, utilising the featured brush;
-
the upper deck and the inside of the cylinder;
-
the front panel, with particular attention for the extraction door, the relative frame and the basin support zone.
7.4
Reassembly
T
HESE
OPERATIONS
MUST
BE
CARRIED
OUT
ONLY
AFTER
DISCONNECTING
MACHINE
FROM
MAIN
POWER
!
-
Assemble blades [31] on beater's supports [6] partially screwing screws [36]. Blades
will be subsequently adjusted.
Carefully place beater into the cylinder, taking care to keep it
vertical without dropping it.
-
The slot on the beater's hub [27] goes into the shaft clutch [28];
-
FIRMLY tighten beater's fixing knob [7];
Before tightening knob [7], always check that the gasket [G] is
in perfect conditions and in place, an that is clear of any fat as
to prevent knob from accidentally coming loose. Should the
knob fall into the cylinder during production cycle, it would
cause serious damage to the machine.
Note:
Gaskets must be periodically replaced (ref. Par. 8.1).
-
put lid in place, insert pin [25];
-
install the chute [9] beneath the extraction door [14], by screwing the knob [16];
-
fix basin support [10] on the front panel with knobs [16];
Summary of Contents for GAMMA 250 MONO
Page 2: ...English Ice cream freezer 2...
