P16.XY20 Piezo Nanopositioning Scanner User Manual
10
Notice:
When mounting the load, tighten the load slowly. The torque should not be too large
to prevent damage to the mechanism.
Avoid stretching and bending cables.
Use the dedicated cable provided by CoreMorrow to connect P16.XY20 and the controller.
Do not connect via an extension cable casually, if you need a longer cable, please
contact CoreMorrow.
5.3 Operating
Please reconfirm the following information before turning on the power:
The P16.XY20 has been grounded.
The operating environment meets the operating environment requirements of P16.XY20.
Fixed screws must be tightened
After the above information is confirmed, relevant controller operations can be carried out:
1.Please read the user manual of the controller carefully before operation, and then start
the controller.
2.Set the controller' output voltage to zero first.
3.Check no abnormal phenomenon, then input voltage value (via keyboard or analog
control) according to specified input voltage range.
4.Operating normally within the rated voltage range of piezoelectric ceramics (0~120V,
maximum 150V).
5.After use, please carry out voltage reset operation.
Please take light steps when P16.XY20 in operation, do not knock the product, so as not to
affect the use of the product or even damage the product.
In order to achieve better motion precision of P16.XY20, it is recommended to use our
company's supporting controller. Please refer to the user manual of the controller for the
specific operation to ensure correct operation before relevant operation.
