Artiglio Master
operator’s manual
61
EN
The inflation pressure must be checked regularly, at least every two weeks and before
long journeys, not forgetting the spare wheel.
The pressure must only be checked with the tyres cold, since the pressure increases
when the tyres heat up during use.
Never reduce the pressure of tyres when they are hot.
Tyres which have not been used for at least one hour, or have travelled not more than 2
or 3 kilometres at low speed, can be considered cold.
The inflation pressures when cold must be those specified for the car by the car or tyre
producer.
For heavy-duty operating conditions (e.g. continuous high speeds, towing trailers, etc.),
where this is not already specified by the car’s handbook, the recommended cold pres-
sures should be increased by 0.3 bar.
MAINTENANCE
WARNING
The “Spare Parts” manual does not authorise the user to do any work on the machine
except for that specifically described in the operator’s manual, but does enable the
user to provide accurate information to the after-sales service, in order to reduce
service times.
WARNING
CORGHI declines all liability for claims deriving from the use of non-original spares
or accessories.
WARNING
Any operation intended to modify the setting value of the relief valve or pressure
limiter is forbidden.
The manufacturer declines all liability for damage resulting from tampering with
these valves.
WARNING
Before making any adjustments or carrying out maintenance, disconnect the electricity
and compressed air supplies from the machine and make sure that all moving parts
are suitably immobilised.
WARNING
Do not remove or modify any part of this machine (except for servicing).
DANGER
When the machine is disconnected from the air supply system, the devices marked
with the warning sign shown above may remain pressurised.
Summary of Contents for Artiglio Master 26 MI
