Corghi Artiglio Master, Manual

Artiglio Master

7

INSTALLATION

The bead pressing arm only functions on Master tyre changers.
The Kit is especially recommended for simplifying the mounting of wheels with particu-
larly tough, hard-to-mount tyres. During the mounting procedure, the Kit places the bead 
inside the drop centre of the rim without the aid of levers or any other tools which might 
scratch and/or damage the rim.

TECHNICAL DATA

- Working range (in inches) ............................................................................... from 12” to 26”
- Operating pressure .....................................................................................................8-10 bar
- Force applied to the wheel ............................................................................ 160 Kg at 9 bar
- Weight ............................................................................................................................... 20 Kg

FITTING THE KIT

 WARNING

This procedure must be carried out without delivery pressure, disconnecting the air 
intake connection A on the FRL unit (fig. 5)

a)  Use the four M8 washers provided to fix the bead pressing arms support to 

the top of the machine, and grease the seat of the pivot pin (fig. 1 and 2).

b)  Lift the assembly (fig. 3).
c)  Grease the pivot pin seat, fit the two shim washers and fit the unit into the support. 

Centre the two shim washers, fit the pivot pin and fix it to the support using the two 
M6 washers supplied (fig. 4 and 5).

d) Use the two M6 washers supplied to fix the side element (fig. 6).
e)  Use the union supplied to connect the bead pressing arm to the FRL unit (fig. 7).
After installation, connect the union 

A

 back to the FRL unit (fig. 5).

GB