EM 9250
Operator’s manual
121
UK
or LEd 2
in this configuration, the light will turn on, in addition to the situations indi-
cated above (in the Led1 mode) also during the entire measurement cycle,
when acquiring dimensions in all balancing programmes and in the Hidden
Weight programme when selecting the two planes behind the spokes.
- press the
key to confirm and exit.
15.11. SET UP - LASER INDICATOR
(IF AVAILABLE)
The machine allows the operator to enable or disable the laser device.
Proceed as follows to make this setting:
- press the
key
- use the
keys to search for SEt UP
- press the
key to confirm
- use the
keys to search for LAS on (LAS oFF if previously set)
- press the
key to change the setting:
LAS on
to enable the laser device
or LAS oFF
to disable the laser device
- press the
key to confirm and exit.
Caution
If the laser indicator is enabled, the application of the adhesive weights (except for the ALU1
P and ALU2 P balancing programs with the weight-holder device present) and the refer-
ence for selecting the two weights behind the spokes (Hidden Weight) is at 6 o'clock (H.6).
15.12. AUTOMATIC POSITION SEARCH (RPA)
When the automatic position search programme is activated, the machine stops the wheel in
the position for application of the outer side weight at the end of every balancing spin; if it is
equal to zero, the wheel is stopped in the inner side weight application position.
