122
EM 9250
Operator’s manual
Press the
button to search for the second side position with the guard raised.
Proceed as follows to deactivate the automatic position search programme:
- press the
key
- use the
keys to search for SEt UP
- press the
key to confirm
- use the
keys to search for rPA on (rPA oFF if previously set)
- press the
key to change the setting:
or rPA on
to enable the automatic position search programme
or rPA oFF
to disable the automatic position search programme
- press the
key to confirm and exit.
16. UNBALANCE CALIBRATION
WITH CALIBRATION WEIGHT
This programme allows sensitivity calibration whenever calibration when it appears to be
out of the tolerance range or when the machine requires this procedure to be performed
by displaying the E 1 error message.
Proceed as follows to recall this programme:
• press the
key
• use the
keys to search for Unb CAL
• press the
key to perform calibration, proceeding as follows:
1. Fit a wheel of average dimensions (diameter no less than 14") on the wheel balancer
with preferably only a small unbalance.
