132
EM 9250
Operator’s manual
MAINTENANCE
CAUTION
The company is not to be held responsible for any claims deriving from the use of non-original
spare parts or accessories.
CAUTION
Unplug the machine from the socket and make sure that all moving parts have been locked
before making any adjustments or maintenance work.
Do not remove or modify any part of the machine (except for service interventions).
WARNING
Keep the working area clean.
Never use compressed air and/or jets of water to remove dirt or residues from the machine.
Take all possible measures to prevent dust from building up or raising during cleaning
operations.
Keep the wheel balancer shaft, the securing ring nut, the centring cones and flange clean. These
components can be cleaned using a brush previously dripped in environmentally friendly solvents.
Handle cones and flanges carefully so as to avoid accidental dropping and subsequent damage
that would affect centring accuracy.
After use, store cones and flanges in a place where they are suitably protected from dust and dirt.
If necessary, use ethyl alcohol to clean the display panel.
Perform the calibration procedure at least once every six months.
INFORMATION REGARDING
MACHINE DEMOLITION
If the machine is to be scrapped, remove all electrical, electronic, plastic and metal parts
and dispose of them separately in accordance with current provisions as prescribed by law.
ENVIRONMENTAL INFORMATION
The disposal procedure described below only applies to machines with the symbol of the
waste bin with a bar across it
on their data plates.
This product may contain substances that can be hazardous to the environment and to hu-
man health if it is not disposed of properly.
The following information is therefore provided to prevent the release of these substances
and to improve the use of natural resources.
Electrical and electronic equipment must never be disposed of in the usual municipal waste
