78
EM 9250
Operator’s manual
Fitting the external mechanical sensor and relative support
(if available)
Refer to the instructions provided with the kit, code 8-21100239 EXTERNAL MEASURING
S INNER CABLE.
Assembly of the ultrasonic sensor and its “optional accessory
supplied on request” support for automatic width measurement
(Only for machines equipped with the RPA programme and wheel
guard)
- Insert the ultrasonic sensor cable inside the slots in the metal pipe (see fig.7) fixing
the cable using the supplied hose clamp
(A, fig.7).
- Fasten the ultrasonic sensor to the guard
pipe with the three supplied M8 screws
(Fig.7a).
- Connect the sensor cable to the connector
on the side of the casing (A, fig.7b).
IMPORTANT: after installing the ultrasonic
sensor, calibrate the sensor as described
in the paragraph “Calibrating ultrasonic
width measuring sensor”.
After installing the machine, move into the
selected location, ensuring that the spaces
surrounding the machine comply with the
minimum dimensions indicated in Fig. 5a.
7
7a
7b
