13
-
Apply medium strength threadlocker (loctite243) to stud bolt B and screw it onto the
pulley.
Replacing the brake shoe
-
Remove the weight-holder lid and the side casing;
-
Select function 100 and press the down arrow key to move the electrical actuator so that
the roller is touching the bell;
-
Unscrew the M6 locknut (D);
-
Extract the pin and recover the Belleville washers;
-
Fit the new brake shoe with the washers removed in the previous step;
-
Tighten down the locknut on the fulcrum pin so that there is no play between the shoe and
the lever; the shoe should be friction fit to the lever.
-
Switch the machine off and on again to enable the balancing machine to calibrate itself
with the new stroke of the spin unit;
-
Run a number of trial spin cycles.
-
Fit the side casing and close the weight-holder lid.
