6
The program is used for:
checking the operation of the sensors used for automatic data input. When the sensors are
moved, the displayed values should vary continuously within the following ranges:
diameter sensor
from 0 to 1000 (+/-10) from standby to full stroke (see
“replacing the diameter sensor”);
distance potentiometer
from 0 to 490 (+/-10) from standby to full stroke;
width potentiometer
from 5 to 245 (+/-10) from standby to full stroke.
99 Preset speed wheel spin setting:
Selecting this program displays the set default speed value (rpm). The arrow keys can be used
to modify the speed setting at which the data will be acquired in subsequent wheel spins
performed in the context of this program.
To exit from the program (and the service environment) press F.
The program is used for:
checking that the unbalance values are calculated precisely for all allowed spin speeds.
100 Electrical actuator control function:
Selecting the program results in the machine displaying:
-
message "Pos" on the LH display;
-
a numerical value which shows the position (in marks) of the electrical actuator, on the
RH display.
The program enables:
•
moving the actuator to the spin or brake position with the START/STOP buttons
respectively.
•
moving the actuator gradually with the arrow keys. This function is particularly important
when servicing or replacing the actuator;
•
moving the actuator to mid-stroke with ENTER;
To exit from the program (and the service environment) press F.
The program is used for:
-
Checking the operation of the electrical actuator and its control logic.
-
Servicing the spin/brake unit.
-
The no load current values (in marks) read by the electrical actuator also appear, both in
spin and brake modes.
101 Counters:
Selecting the program results in the machine displaying the following counters:
•
[LAN
TOT] n. of spin cycles run;
•
[LAN
CAL] n. of spin cycles run since the most recent sensitivity calibration,
•
[N°
PIS]
n. of electrical actuator cycles.
Press Enter to select the counter you wish to display.
MBE161 MOTHERBOARD SWITCH CONFIGURATION
The circuit boards on the balancing machine are equipped with hardware and software to
enable their use on a variety of models. They are already configured to operate correctly and
do not require configuration.
