1
IMPORTANT:
NOTE: DO NOT RETURN UNIT TO THE STORE
BEFORE CONTACTING OUR CUSTOMER SERVICE
DEPARTMENT. DO NOT DISPOSE OF YOUR
CARTONS UNTIL YOU ARE COMPLETELY SATISFIED
WITH YOUR NEW FIREPLACE HEATER.
PLEASE NOTE: WHEN YOU OPEN THE CARTON CAREFULLY CHECK
THE UNIT AND MAKE SURE THERE IS NO DAMAGE. IF YOU HAVE
ANY PROBLEMS WITH ASSEMBLING THE UNIT, WITH HOW THE
VARIOUS FUNCTIONS WORK OR WITH DAMAGE OR MISSING PARTS,
PLEASE GO TO OUR WEBSITE:
www.CorLiving.com/parts
NOTE:
Light bulbs may become loose during shipping. If the flame effect is dim or does not
work, please check that light bulb or bulbs are finger tight in socket. See instructions for
replacing bulb or bulbs.
NOTE:
The electric fireplace heater may emit a slight harmless odor when first turned on.
This is caused by activating the internal heater components for the first time and should
not occur again.
INSTRUCTION MANUAL
ATTENTION:
1. Find a location for the fireplace heater that is protected from direct sunlight.
2. Do not plug the unit into the power outlet before reading all instructions.
IMPORTANT SAFETY
INSTRUCTIONS
WHEN USING ELECTRICAL APPLIANCES, BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWED
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, AND INJURY TO PERSONS, INCLUDING THE
FOLLOWING:
1) Read all instructions before using this electric fireplace heater.
2) This electric fireplace heater is hot when in use. To avoid burns, do not let bare skin
touch hot surfaces. The grill directly in front of the heater outlet becomes hot during
heater operation. Keep combustible materials, such as furniture, pillows, bedding,
papers, clothes, and curtains at least 3 ft (0.9 m) away from the front of the unit and
keep them away from the sides and rear.
3) Extreme caution is necessary when any heater is used by or near children
or individuals with disabilities and whenever the fireplace is left operating and
unattended.
4) Always unplug fireplace when not in use.
5) Do not operate any electric fireplace with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner.
6) Do not use outdoors.
7) This electric fireplace heater is not intended for use in bathrooms, laundry areas and
similar indoor locations. Never locate heater where it may fall into a bathtub or other
water container.
8) Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Arrange cord away from traffic area and where it will not be tripped over.
9) To disconnect fireplace, turn controls to off, then remove plug from outlet.
10) Connect to properly grounded outlets only.
11) Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this
may cause an electric shock or fire, or damage the heater.
12) To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use
on soft surfaces, like a bed, where openings may become blocked.
13) A heater has hot and arcing or sparking parts inside. Do not use it in areas where
gasoline, paint, or flammable liquids are used or stored.
14) Use this fireplace heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or injury to persons.
15) Avoid the use of an extension cord because the extension cord may overheat and cause
a risk of fire. However, if you have to use an extension cord, the cord shall be No.14 AWG
minimum size and rated not less than 1875 watts.
16) Do not plug this product into a receptacle controlled by a wall switch or dimmer.
17) When storing or transporting the unit and cord, keep in a dry place, free from excessive
vibration and store so as to avoid damage.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE.
CAUTION:
If you use this heater in conjunction with a thermal control, a program controller, a timer or
any other device that switches the heater on automatically, remember to observe all safety
warnings at all times. The fireplace heater has safety overheat protection. If the overheat
protection trips, switch off all switches and wait approximately 5 – 10 minutes. It should
reset automatically once the unit cools down.
WARNING: PROCEDURES AND TECHNIQUES, IF NOT CAREFULLY FOLLOWED, WILL RESULT IN
DAMAGE TO THE EQUIPMENT, AND WILL EXPOSE THE USER TO THE RISK OF SERIOUS INJURY,
ILLNESS OR DEATH.
PO#
32” Wall Mount Fireplace
Model : FPE-20
6
-F
This electric fireplace heater is for use on 120 volts. The cord has a plug, as shown at A
in illustration below. An adapter, as shown at C, is available for connecting three-blade
grounding-type plugs to two-slot receptacles. The green grounding plug extending from the
adapter must be connected to a permanent ground such as a properly grounded outlet box.
The adapter should not be used if a three-slot grounded receptacle is available.
A 15 amp circuit is required to operate this heater. If the breaker trips when the heater is used,
you may need to move the heater to another location or unplug other appliances that are on the
same circuit. If you require an extension cord, use one that is rated at 1875 watts.
