8
User manual
CM 1200 BB
Check that the pressure and flow-rate provided
by the compressed air system are compatible
with those required for proper operation of the
machine - see the "Technical data" chapter. For
correct machine operation the compressed air
supply line must provide a pressure range from
no less than 8 bar to no more than 16 bar.
Connect the compressed air system by means
of a supply pipe connected to the intake of
the air treatment unit on the REAR SIDE of the
machine base.
Check that there is air lubrication oil in the
Lubricating unit; refill if there is little or no oil.
Use SAE20 oil.
The customer must provide an air shutoff valve
upstream of the air treatment and regulating
device supplied with the machine.
1
6
WARNING
Connection
1 should be considered as an
emergency valve to disconnect the machine
from the air line (fig.6).
SAFETY REGULATIONS
The equipment is intended for professional
use only.
WARNING
Only one operator may work on the equipment
at a time.
WARNING
Failure to comply with the instructions and
danger warnings may seriously injure operators
and any other person near the machine. Do not
operate the machine until you have read and
understood all the danger, warning and caution
notices in this manual.
This machine must be used only by qualified and
authorised personnel able to understand the
written instructions provided by the manufactu-
rer. He must be suitably trained and conversant
with the safety procedures. Operators must not
use the machine under the influence of alcohol
or drugs which may affect their capacity.
The operator must, in all cases:
- be able to read and understand all the infor-
mation in this manual;
- have a thorough knowledge of the capabilities
of this machine;
- keep unauthorised persons well clear of the
area of operation;
- make sure the machine has been installed in
compliance with all relevant regulations and
legislation;
- make sure that all machine operators are suita-
bly trained, that they are capable of using the
equipment correctly and safely, and that they
are adequately supervised;
- never leave nuts, bolts, tools or any other
equipment on the tyre changer as they may
become entrapped between moving parts;
- not touch power lines or the inside of electric
motors or any other electrical equipment be-
fore making sure the power supply has been
disconnected;
- read this manual carefully and learn how to use
the machine correctly and safely;
- always keep this user and maintenance manual
in an easily accessible place and consult it
whenever necessary.
Summary of Contents for CM 1200 BB
