Technical Support Manual – 05/2018 Rel. 2.1.3
Page 25
4
Browse the list of the menus with [P4]
or [P5]
until the option
required is displayed.
5
Press [F+P5]
to
confirm the selection. The default
measurement of 520 mm of the distance
from the Distance/Diameter sensor to the
SONAR device is displayed.
6
By means a measuring tape, measure the
distance between the diameter
sensor/gauge and the SONAR DEVICE. Read
the measured value.
7
Change the value with the [P4]
or
[P5]
until the measured value is
shown on the display.
Example
8
Press [F+P5]
.
Example
9
To exit press [F+P5]
10
To exit the Menu Parameters select the
option
Ret
then press [F+P5]
.
RET
Return
This option allows you to return to the Sensor Calibration Menu.
Summary of Contents for MEC 10
Page 1: ...WHEEL BALANCERS MEC 5 MEC 10 MEC 15 MEC 20 TECHNICAL SUPPORT MANUAL UK...
Page 2: ......
Page 38: ......
