Use and Maintenance Manual – 09/2016 Rel. 0
Page 15
13.1 Keyboard
In this manual, the keys are numbered for convenience from [P1] to [P10] as shown in picture F13.1. Beside the key reference
numbers the key symbols (for an easy-to-read) are shown. The ten buttons have a main function indicated by a symbol in the big
circle and a secondary function indicated by the symbol in the small circle located along side. Some of the secondary functions feature
a led to indicate their activation. The keys [P7]
, [P8] Start
and [P10] Stop
do not have a secondary
functions. The secondary function of the keys is identified in this manual with the codes from [F+P1] to [F+P9] as shown in picture
F13.3.
Figure F13.2: Key sample showing the main and secondary function
To enter the secondary function of the keys press the key [P7]
then, by holding down, press one of the keys for the
secondary function you want, then release both keys.
Figure F13.3: Numbering of the secondary function of the keys
Table T13.2: Settings, programs and menu available in the SERVICE mode
SERVICE mode
Key
Setting/Program or Menu
Key
Setting/Program or Menu
[P1]
Not used
[F+P1] Not used
[P2]
Not used
[F+P2] Select weight material in Fe/Zn or Pb
[P3]
Machine calibration
[F+P3] Exit SERVICE mode (return to the NORMAL mode)
[P4]
Grams/ounces selection
[F+P4] Read counter with the number of spins
[P5]
Inches/mm selection
[F+P5] Parameters MENU
(Menu with password reserved for technical service)
[P6]
Select the imbalance threshold view
[F+P6] Not used
[P9]
Not used
[F+P9] Test programs MENU
Main function of the key.
This is the key to be press.
Secondary function of the key.
It is only a graphic illustration. A led light
on means the secondary function is
enabled.
[F+P1]
[F+P4]
[F+P5]
[F+P6] [F+P9]
[F+P2] [F+P3]
Summary of Contents for MEC 200 TRUCK
Page 1: ...WHEEL BALANCERS MEC 200 TRUCK MEC 200 C TRUCK USE AND MAINTENANCE MANUAL UK...
Page 2: ......
Page 4: ......
Page 43: ......
