Use and Maintenance Manual – 09/2016 Rel. 0
Page 23
8.
Press the [P3] key
to change the diameter and press the [P4]
or [P5]
within 1.5 seconds to
enter the read value. If neither of these two buttons is pressed in this time limit, the machine will return to the previous
display. In this case, you can press the [P3] key again
to enter or edit the data.
Figure F15.2: Manual acquisition of the wheel size: distance sensor fixing
15.3.2 Entering wheel size for Program Types ALS1, ALS2
To manually enter a wheel size, proceed as follows:
1.
Fit the wheel on the shaft;
2.
If the selected program type is ALS1, extract the distance sensor and place it on the wheel as shown in Figure F15.3
otherwise proceed with step 4;
3.
If the selected program type is ALS2, remove the distance sensor and place it on the wheel as shown in Figure F15.4;
4.
Read the internal plane distance value on the graduated scale. The distance value is always expressed in millimetres;
5.
Press the [P1] key once
to view the parameter
di1
(
internal plane distance) and, within 1.5 seconds, press the
[P4]
or [P5] key
to enter the read value. If neither of these two buttons is pressed in this time limit,
the machine will return to the previous display. In this case, you can press the [P1] key again
to enter or edit the
data;
6.
Remove the distance sensor and place it on the plane selected for the external weight as shown in Figure F15.5;
7.
Read the distance value on the graduated scale. The distance value is always expressed in millimetres;
8.
Press the [P1] key
twice in quick succession until
di2
(
external plane distance) is viewed and, within about 1.5
seconds, press [P4]
or [P5]
to enter the read value. If neither of these two buttons is pressed in this
time limit, the machine will return to the previous display. In this case, you can press [P1] key
twice in rapid
sequence to enter or edit the data;
9.
Press [P3] key
to view
da1
(
internal plane diameter) and within about 1.5 seconds press [P4]
or [P5]
to enter the value obtained with one of the two methods specified in the below note. If neither of these two
Summary of Contents for MEC 200 TRUCK
Page 1: ...WHEEL BALANCERS MEC 200 TRUCK MEC 200 C TRUCK USE AND MAINTENANCE MANUAL UK...
Page 2: ......
Page 4: ......
Page 43: ......
