Use and Maintenance Manual – 08/2018 Rel. 4
Page 42
19.3 Electromagnetic clamping brake
The electromagnetic clamping brake is useful to block the wheel in any position defined by the user and to simplify some operations
such as the application or removal of balancing weights.
The electromagnetic clamping brake is also used in the automatic or manual stopping of the wheel on imbalance positions described
in chapter 19.5
SWI Wheel stop procedure on the positions of imbalance.
To activate and/or deactivate the ELECTROMAGNETIC CLAMPING BRAKE, proceed as described below:
Ph.
1
Press on icon.
The electromagnetic clamping brake is deactivated automatically in the following cases:
•
Every time a balancing launch is run;
•
Every time a SWI procedure is performed (stop of the wheel on the imbalance position) at low speed;
•
After one minute of continuous activation (to avoid overheating of the brake itself).
The electromagnetic clamping brake can be used manually only in NORMAL mode. It cannot be used in the SERVICE mode.
