Technical Support Manual – 03/2017 Rel. 0
Page 45
12
At the end of the spin, the MOTO
wheel type calibration is finished
and the machine will switch to
NORMAL mode, ready to run the
balancing.
13
To exit at any time the calibration
procedure during its progress,
press on icon.
The MOTO wheel type and the
ALU1 Program Type will remain
set and the wheel dimensions will
be those which were
automatically set by the machine
for this kind of calibration.
If you have anomalies during the calibration procedure, the machine will display the error message (for example ERR 025). See
chapter
“5. Error codes”
to solve the problem and continue/repeat/cancel the calibration in progress. Launches that are interrupted
by lifting the wheel guard can be repeated by lowering the wheel guard back down.
Summary of Contents for TOUCH MEC 1000 SONAR
Page 1: ...WHEEL BALANCERS TOUCH MEC 1000 SONAR TECHNICAL SUPPORT MANUAL UK...
Page 2: ......
Page 53: ......
