IDC Pro 255 Service Manual
Publication Number: 621058649SER
- 32 -
© 2016, Cornelius Inc.
U
NIT
O
PERATION
!
WARNING:
This unit must be grounded to avoid possible electrical shock to the operator. The unit power cord is equipped with a
three pronged plug. If a three pronged (grounded) outlet is not available use an appropriate method to ground the
unit.
Failure to comply could result in serious injury, death or damage to the equipment.
To initially start up the unit for operation, perform the procedure in Table 21.
6
With a nylon bristle brush or
sponge, clean the inside of the ice
chute, gasket, and cover with
soap solution and rinse thor-
oughly to remove all traces of
detergent.
Figure 64.
7
Re-assemble the ice chute assembly.
8
Using a mechanical spray bottle
filled with sanitizing solution, spray
the inside of the ice chute. Allow it
to air dry.
Figure 65.
9
Close the display panel.
Table 21.
Step
Action
1
Connect electrical power to the unit.
2
Check for water leaks, and tighten any loose connections.
3
Dispense several drinks for checking.
Table 20.
