Manual Installation Conversion Kit 4.1 To 4.2
Publication Number: 629097805INS
- 12 -
©2019, Cornelius Inc.
27. Install the (2) adhesive backed LTE antennas, one inside door pocket and one at top center of door (Figure 20). Use the
supplied clips, to secure the antenna cables in place. Be sure the clips ‘snap’ close and that the surfaces on which the
antenna and clips are mounting to are clean and free of dirt, oils or foreign matter.
Figure 20
28. The ‘old’ modem antenna cable left behind (Figure 20.1) can be coiled up and secured the door service panel or inside the
main unit. be sure this cable does not interfere with any other component or unit operation.
Figure 20.1
29. Route new ADA cable
a) Remove ADA access cover and disconnect connection shown below.
b) Coil up upper half of ADA cable so it’s out of the way.
c) Route new cable supplied in the kit down thru the opening until it reaches the ADA board. Carefully pull thru, place
over the ADA board and loop down to ADA board connection and pull into the board.
Install at Top
Center of Door
Inner door pocket
Antenna-AUX
AUX Antenna cable path
path
Main Antenna cable
Top center antenna-MAIN
Attach Antenna cable here
inner door pocket
Install inside of
old modem
antenna cable.
