3
FAN BODY ASSEMBLY INSTRUCTIONS
1. Unscrew the spinner clockwise and the nut counter-clockwise to remove both
of them.
2. Set the rear guard in the proper position with handle up.
3. Screw on plastic nut tightly to attach rear guard.
4. Discard plastic sleeve on motor shaft.
5. Install the blade onto the motor shaft until it reaches the retaining pin.
6. Screw spinner onto motor shaft counter clockwise to blade.
7. Press the rim of the rear guard onto the front guard until the rear guard is
properly fitted.
8. Secure both guards firmly by tightening the fan guard then close easy clip.
FAN OPERATING INSTRUCTIONS
1. SPEED REGULATOR:
Speed is controlled by pressing
Buttons of speed regulator on the
Top of body (4 buttons: 0—off, 1—low,
2—medium, 3—high).
2.
TIMER
Turn the knob of timer to position which
Set the time you want. The fan will stop
When the time is over. The longest time set is 60 minutes. In case the timer is
not use, set the timer to “ON”
NOTES: The fan can not run if timer is on “0” position
Summary of Contents for CFN-E160T
Page 1: ...1 CFN E1 6 0T 1 6 Stand Fan With Timer ...
Page 5: ...0 ...
