6
AXYGEN MICROTUBE SHAKER
5.2 Start and Stop
Start:
Complete the parameter input, push the knob to begin the protocol. Run indicates
the experiment is in progress.
Pause:
Press the knob once to pause at any time during a Run.
In the Actual value column Pause will be displayed during a desired temporary pause in
the experiment. When in this state, only the Timer and Mixing functions are paused, the
Temperature Control function is still consistent with the temperature at the point of pausing.
Resume:
Press the knob once to resume to the Run while in the Pause phase.
Stop:
Press and hold the knob to stop the current Run.
5.3 Running
5.3.1 Single Step Work Without Saving
When powered On, the LCD screen shows the parameters of the last run, or factory settings.
Press the Temp, Speed, Time function buttons respectively, the corresponding characters will
flash. Rotate the knob to set each parameter according to the standard operating procedure
of the experiment. If Time is set to 00:00, it will run in continuous mode. After the setting is
completed, press the knob to start work.
