STANDARD RECOMMENDED PROCEDURE 003-787 | ISSUE 1 | AUGUST 2008 | PAGE 2 OF 2
Corning Cable Systems LLC
√
PO Box 489
√
Hickory, NC 28603-0489 USA
1-800-743-2671
√
FAX +1-828-325-5060
√
Interna1-828-901-5000
√
http://www.corning.com/cablesystems
Corning Cable Systems reserves the right to improve, enhance, and modify the features and specifications of Corning Cable Systems’ products without prior notification.
All trademarks are the properties of their respective owners. Corning Cable Systems is ISO 9001 certified.
©
2008 Corning Cable Systems. All rights reserved. Published in the USA.
=
3.
Connect Jumpers to CWDM Modules
Step 1:
Pull module out to detent position (Figure 3).
Step 2:
Press buttons on each side of the module (Figure 4) and lower the handle.
Step 3:
Remove dust caps and clean adapters and connectors per standard company practice.
Step 4:
Refer to the designation label (Figure 2) on the handle of the module for the port
designations to determine where your jumpers should be connected.
NOTE:
The first port on the left is empty and not available for use.
•
Connect the common port jumper to the port labeled “COM.”
•
Connect the remaining jumpers to the applicable port with the desired wavelength as
shown on the designation label.
•
To monitor the module, insert a test jumper into the port labeled “MON.”
Step 5:
Connect jumpers (Figure 5) as required.
Step 6:
Raise handle. Dress jumper cords (Figure 6) to the side of the module.
Step 7:
Push module back into the housing and dress jumper cords in frame as described in the
installation instruction provided with the housing.
IMPORTANT:
Guide fibers while inserting module to avoid pinching fibers.
KPA-2135
Button
M.
MUX
N/A
COM
MON
1310
1471
1491
1511
1531
1571
1591
1611
1551
Figure 4 — Lower Handle
KPA-2134
M.
MUX
N/A
COM
MON
1310
1471
1491
1511
1531
1571
1591
1611
1551
Figure 3 — Pull Module Out
11
10
4
3
2
1
6
5
MON
1471
KPA-2137
MUX
MON 1310
1471 1491
1511 1531
1551 1571
1591 1611
COM
N/A
MUX
1310
N/A
Figure 6 — Dress Jumper Cords
12
11
1
7
10
9
4
3
2
1
8
7
6
5
N/A
MUX
MUX
MON 1310
1491 1511
1531 1551
1571 1591
1611
COM
KPA-2136
Figure 5 — Connect Jumpers
