MA 1000M Installation and Configuration Guide
5
2
S
S
y
y
s
s
t
t
e
e
m
m
E
E
l
l
e
e
m
m
e
e
n
n
t
t
s
s
This chapter describes the MA1000 system basic elements: remote modules (1000 RHU and Add-
on) and the Base Units. Your system may include additional elements such as 410, 430 and SC-
450 controllers, RIUs and 860 WLAN solution units; these are described in the corresponding
User Guides.
2.1
Remote Modules
The Optical to RF conversion of each service at the individual building floors is performed by
remote units corresponding to the service types. These consist of 1000 RHUs and in addition,
may include Add-on modules and 860 WLAN solution modules.
The configurations depend on the requirements of the site and the supported services. The
following sections describe each of the system elements.
NOTE: The connections as they relate to the MA 1000 system are described in Chapter
4 -
System Installation.
2.1.1
MA1000 RHUs
Each RHU supports two different services (one high-band and one low-band). All RHUs are add-
on ready, meaning that their optic interface and control functionality can support a third (high-
power) service through the connections of an Add-on module (see section
4.3.2.1).
Each 1000 RHU is connected to the corresponding BU (located in the communication room)
through a fiber optic connection. Remote monitoring is provided through the BU connections to
the 410, 430 and SC-450 controller (
1.4).
The 1000 RHU services, add-on service and data services (provided by 860 WLAN system) at
each location are combined and then transmitted over a common infrastructure to strategically
placed antennas.
