Preface
MA1000 Installation and Configuration Guide
III
P
P
r
r
e
e
f
f
a
a
c
c
e
e
M
M
a
a
t
t
e
e
r
r
i
i
a
a
l
l
Installation Safety
•
Follow all safety regulations when installing the MA1000 system
•
Only qualified personnel are authorized to install and maintain the MA1000 system
•
The equipment is intended for installation in restricted access locations only
RF Safety
To comply with FCC RF exposure compliance requirement, adhere to the following warnings:
Warning! To comply with FCC RF exposure compliance requirements, antennas used for this product must be
fixed mounted on indoor permanent structures, providing a separation distance of at least 40 cm from all
persons during normal operation.
Warning! Antenna gain should not exceed 12.5 dBi.
Warning! Each individual antenna used for this transmitter must be installed to provide a minimum
separation distance of 40 cm or more from all persons and must not be co-located with any other antenna for
meeting RF exposure requirements.
Warning! The design of the antenna installation needs to be implemented in such a way so as to ensure RF
radiation safety levels and non-environmental pollution during operation.
Caution! Use of controls or adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure.
Compliance with RF Safety Requirements
•
Corning MobileAccess products have no inherent significant RF radiation
•
The RF level on the down link is very low at the Remote Hub Unit (RHU) downlink ports. Therefore, there
is no dangerous RF radiation when the antenna is not connected.
Laser Safety
•
Fiber optic ports of the MA1000/2000 emit invisible laser radiation at the 1310 nm wavelength window.
•
To avoid eye injury never look directly into the optical ports, patchcords or optical cables. Do not stare into
beam or view directly with optical instruments. Always assume that optical outputs are on.
•
Only technicians familiar with fiber optic safety practices and procedures should perform optical fiber
connections and disconnections of the MA1000/2000 modules and the associated cables.
•
MA1000/2000 complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to laser notice
no. 50 (July 26, 2001) & IEC 60825-1, amendment 2 (Jan. 2001).
