PSG-1400
4
Rev. 07/24/07
FOR BEST PERFORMANCE, PLEASE BE SURE TO DO
THE FOLLOWING BEFORE USING THIS TOOL
• Tighten the gun to the cup securely with the nut and fitting supplied.
• Be sure to have the proper air pressure at the gun to operate. Proper air pressure for this tool should be
5 PSI for lacquer and 50 PSI for enamel.
• Adjust fluid control screw and spray width adjustment screw to your desired pattern before using
on production.
• Clean all parts after use.
SPRAYING
ADJUSTMENTS
In normal use, the nozzle wings are horizontal as
shown here. This provides a vertical fan-shaped
pattern which gives maximum, even,
material coverage as the gun is
moved back and forth parallel to
the surface being finished.
Spray pattern may be infinitely
adjusted from round to flat.
Set atomization pressure at no more than 50 PSI. For
optimum performance, some materials may spray
better at PSI ratings below 50. If unsure, always test
at PSI ratings before using on final production. Try
spray. If it is too fine, decrease the air pressure or
open fluid control screw. If the spray is too thick,
close the fluid control screw. Regulate the pattern
width and repeat adjustment of spray as needed.
®
®
®
Fluid control screw
Turn right to decrease flow, left to increase.
Spray width adjustment screw.
Turn right for round, left for fan.
