※
Push the Control Knob and turn clockwise to the "OFF" position.
TO LIGHT
※
The propane cylinder must be disconnected and removed from the fire pit before the appliance can be stored indoors.
※
Be careful not to let any powder or solvent come in contact with painted or plastic components as damage may occur.
※
After the burner and lava rocks are completely cooled down, use a soft brush to get rid of the mild stains,loose dirt and soil.
Wipe with a soft cloth.
※
Store the fire pit in a cool dry place away from direct sunlight.
※
Store the gas cylinder in a dry, well-ventilated and sheltered area protected from inclement weather and dust, out of the
reach of children, and not in a building, garage or any other closed area.
※
Visually inspect burner from obstructions, keep tank enclosure free and clear from debris.
※
Keep your firepit free and clear from combustible materials.
※
Turn the T-handle on the gas tank clockwise to close the gas supply if not for use in a long time.
※
Installation and repair should be done by a qualified service person.The appliance should be inspected before use and at
least annually by a qualified service person.More frequent cleaning may be required as necessary .It is imperative that control
compartment,burners and circulating air passageways of the appliance be kept clean.
※
Make sure both the gas and the fire pit are turned off before changing battery. Please refer to the process of assembling
battery.
※
Use Manufacturer approved or supplied replacement parts and accessories only. Otherwise may void the warranty of this
product and result in a hazardous condition.
※
If replacement parts are needed, please contact Hayneedle, Inc. Customer Service Center at 1.888.880.4884
MAINTENANCE
Before each use, inspect all hose. Replace hose if there are any signs of cutting, wear or abrasion.
(1) Turn the T-handle on the gas tank counter-clockwise to open the gas supply.
(2) Light the firepit as below steps:
A. Push and turn the Control Knob counter-clockwise to the "LOW" position. Keep pushing the Control Knob. Meanwhile press
and hold the Electric Ignitor to light the burner .
B. After ignition, release the Electric Ignitor. Continue to push and hold the Control Knob for 15 seconds.
C. If ignition does NOT immediately take place in seconds, push and turn the Control Knob clockwise to "OFF". Wait 5
minutes, then repeat the lighting procedure as above.
6
