14 di 80
2 - 04.2014
CORRADI SPA - mAnuAle uTenTe - eXPeRIenCe
ManutEnzIonE
PuLIzIa
I trattamenti superficiali dei profilati in alluminio, sia
anodizzazione che verniciatura, sono delle migliori qualità e
costantemente controllati, si consiglia tuttavia di eseguire una
pulizia periodica (almeno tre volte all’anno) consistente nel
lavaggio delle parti in alluminio con sola acqua e detergente
neutro. Si devono assolutamente evitare prodotti alcalini
o acidi, prodotti abrasivi, solventi organici o detergenti di
composizione chimica sconosciuta. Le superfici e i detergenti
usati durante il lavaggio devono essere a temperatura massima
di 20 °C, non usare macchine a spruzzo di vapore. La pulizia
dovrà avvenire con maggiore frequenza nelle aree ricche di
salsedine o di particolari agenti inquinanti.
Per il buon scorrimento dei carrelli, mantenere pulite le guide
inferiore e superiore; assicurarsi che tutte le guarnizioni siano
ben pulite, eventualmente passandole leggermente con un
panno umido.
È essenziale, al fine di mantenere la corretta capacità di
evacuazione dell’acqua piovana dalla struttura, controllare
periodicamente che i fori di drenaggio non siano ostruiti da
eventuali corpi estranei (grumi di polvere, residui di foglie o
detriti di qualunque genere) che impediscano lo spontaneo
deflusso dell’acqua.
Per quanto riguarda gli accessori di movimentazione e
chiusura, onde mantenere inalterata nel tempo la corretta
funzionalità, provvedere periodicamente (almeno una volta
all’anno) alla verifica delle parti mobili, controllando la tenuta
delle viti di fissaggio e provvedendo alla sostituzione delle parti
eccessivamente usurate. Pulire e lubrificare le parti a contatto,
utilizzando olio siliconico.
Qualora debbano essere eseguiti interventi edili di particolare
rilevanza, occorre proteggere accuratamente le superfici in
quanto il contatto con malta umida, con gesso o altri materiali,
può causare danni ai profilati in alluminio quali corrosione ecc.
SMaLtIMEnto
Il sistema non contiene materiali che comportano rischi alle
persone e all’ambiente e deve essere conferito ad un centro di
raccolta per la rottamazione e la raccolta differenziata dei vari
materiali che la compongono.
n.b.
L’irraggiamento solare provoca il naturale riscaldamento delle
superfici esposte (esterne) che, specie nel caso di finiture di
colore molto scuro, può arrivare a raggiungere temperature
relativamente elevate (anche 60 °C ed oltre); quando le
condizioni climatiche esterne sono particolarmente rigide
invece, la temperatura delle superfici esposte (esterne) può
scendere notevolmente (anche al di sotto di 0 °C). A seguito
di ciò, essendo l’alluminio un buon conduttore termico, si
può verificare l’inconveniente di avere le superfici interne
dei profilati ad una temperatura molto alta (disagio e persino
pericolo di scottature nel toccare e manovrare le sezioni) o
troppo bassa (possibile formazione di condensa). Prestare
dunque le dovute cautele.