50 de 80
CORRADI SPA - MAnuel utIlISAteuR - eXPeRIenCe
2 - 04.2014
avErtISSEMEntS Et PrECautIonS
ControLE PrELIMInaIrE
A la réception de la marchandise emballée, si l'opération
de montage n'est pas effectuée par le revendeur, contrôler
l'intégrité du matériel et la présence de tous les composants
nécessaires.
En cas d'anomalies, contacter le revendeur agréé.
ELIMInatIon DES EMbaLLaGES Du MatErIEL
Subdiviser les différents matériaux selon leur matériau de
composition (carton, Nylon, polystyrène etc.) et procéder à leur
élimination sélective, dans le respect de la réglementation en
vigueur.
avErtISSEMEntS GEnErauX
Avant toute opération de montage, d'entretien ou de
nettoyage du produit, il faut s'assurer que l'on a bien compris
les explications de la présente notice.
Chaque produit Corradi SpA a une fonction spécifique décrite
dans ce manuel; tout emploi différent et non prévu dans les
instructions, l’emploi de composants non originaux, toute
altération et/ou modification technique non autorisée,
déchargent Corradi SpA de toute responsabilité en cas de
dommages subis par les personnes, les biens ou les animaux.
Le personnel chargé de l'installation du produit (doit être doté
des compétences spécifiques ainsi que des critères d'aptitudes
et psychophysiques nécessaires à l'exécution de ses tâches;
il doit par ailleurs respecter scrupuleusement les normes de
prévention des accidents en vigueur.
ConSIGnES DE SECurItE
Il convient de ne jamais oublier que chaque organe en
mouvement peut constituer un danger.
Pendant toutes les opérations d’entretien, de réparation ou
de réglage du produit, il est toujours obligatoire de couper
l’alimentation électrique (sur le modèle motorisé). Il est
conseillé par ailleurs de placer un panneau de signalisation sur
l’interrupteur général d’alimention électrique avec l’indication
suivante :
“NE PAS TOUCHER – travaux de maintenance en cours”.
Il est recommandé de s’assurer qu’aucun opérateur ne se trouve
à proximité du store avant de le remettre en marche après
une intervention d’entretien. Contrôler systématiquement le
fonctionnement et l’efficacité des commandes manuelles et
électriques après la maintenance; en cas d’anomalie cesser
immédiatement toute intervention et contacter l’assistance
technique de Corradi.
DEMoLItIon
Au moment de la démolition, il est nécessaire de séparer les
pièces en matière plastique qui doivent être envoyées au tri
sélectif dans le respect des dispositions en vigueur.
En ce qui concerne la masse métallique du produit, il suffit de
séparer les parties en acier et celles composées d'autres métaux
non ferreux ou d'alliages, pour un envoi correct au recyclage en
vue de leur fusion.