© Corroventa Ltd.
2017.07
7 (27)
Electrical connection
The machine is connected to the earthed 230V/50Hz socket. K3 ES HP can be connected to a 10A,
max 16A, fuse.
Electronic control delays the start max 2 minutes.
Starting and operating
•
Operating range humidity: 30-100% RH
•
Operating range temperature: +9°C to +38°C
•
The dryer must reach ambient temperature before starting, if stored in colder conditions.
1.
Place the dryer on a firm and flat surface where it is not at risk of overturning. The surface
should not be sensitive to water as some spillage may occur, for example when handling the
condensation water hose.
2.
The dryer must be placed at a distance of at least half (0.5) a metre from walls and ceilings to
ensure that air can circulate.
3.
If possible, close doors and windows etc. to use all the dehumidification capacity in the
intended space rather than to dry the whole house/building. To minimise power
consumption, try to ensure that the ambient temperature is approximately 20°C.
4.
The dryer's hose for condensation water is routed to a drain, sink or similar frost-free runoff
for continuous operation.
5.
The ambient temperature must be +9°C to +38°C.
6.
K3 ES HP is equipped with demand controlled defrosting. If ice forms on the evaporator, the
dryer defrosts automatically by stopping the machine. The machine restarts automatically
when the evaporator is clear of ice.
For use on sensitive surfaces, note the following:
When the machine is turned off, any frost on the evaporator thaws and, if there is a lot of frost, this
can cause spillage because the pump is off.
