ENGLISH
8
CHARGING 1
GETTING STARTED
Connect the wireless USB
transmitter
to any working USB port on your PC or connect
the base station (included with the Special Edition models), and then attach the
wireless transmitter to the base station.
Using the USB extension base station may extend the wireless range of your CORSAIR
VOID PRO RGB Wireless Headset, by enabling you to position the antenna for
best reception. The headset is designed to operate at a range of up to 40 feet (12m)
from the wireless
transmitter
, but other wireless devices, electronics, and obstructions
such as walls may reduce wireless range.
IMPORTANT:
The first time you use the CORSAIR VOID PRO RGB Wireless Headset
transmitter
on a PC, the operating system will automatically install the device driver.
After the device driver loads, we recommend you reboot your PC before use.
Status LED
indications:
Single Blink Red = Connected, Battery Low
Single Blink Green = Connected, Battery Normal
Rapid Blink Red = Disconnected, Battery Low
Rapid Blink Green = Disconnected, Battery Normal
Solid Amber = Battery Charging
Soild Green = Battery Charged
Rapid Blink Amber = Pairing Mode
IMPORTANT:
The CORSAIR VOID PRO RGB Wireless Headset must be fully charged before its
first use.
• Connect the USB charging cable to any working USB port on your PC
• Connect the USB charging cable to the CORSAIR VOID PRO RGB Wireless Headset
The CORSAIR VOID PRO RGB Wireless Headset battery has no “memory effect”, so
there is no need to completely discharge it before recharging.
Remember that the USB charging cable requires a high power (USB 2.0 or better) port.
Some USB ports found on older devices do not support USB 2.0.
CHARGING WHILE POWER IS OFF:
When the VOID PRO Headset is OFF, and CHARGING with a connected USB cable.
