- 9-
Connecting the Telephone Line Cords
One coiled handset cord and a long straight telephone line cord are packed with this unit. Insert one modular
plug of the coiled cord into the handset jack and the other plug into the jack on the left side of the base. Similarly,
insert one modular plug of the straight telephone cord into the Line Modular Jack at the rear end of the base and
the other plug into the telephone wall jack as shown in Figure 3.
Figure
3
If your phone system is hard-wired (does not use jack), you must install an RJ11W modular jack. These jacks are
available from your local telephone company or from an electronic and hardware retailer. If you have the older
style 4 pin jacks, adaptors are available to convert them to modular style jacks.
Desktop Usage
1. Attach the supplied
Desk / Wall Mount Bracket
onto the bottom of the telephone (as shown below), if you
want to change the angle of the display.
NOTE: Arrow signs are printed both on the Desk / Wall Mount Bracket and the bottom of the
telephone.
2.
Make sure the arrow signs are matched between the bracket and the bottom of the telephone. “FOR DESK
USE PUT BRACKET HERE” is printed on the bottom of the telephone for desk mount installation. Locate
and snap the tabs into place as shown in Figure 4.
Figure 4
Wall Mounting
There are two different methods for installing the base as follows:
