2
3
DESCRIPTION
1 - Base
2 - Cover
3 - Suction mushrooms
4 - Resistance
5 - Fan
6 - Egg separators (6 separators for AF25 - 8 separators for AF50)
7 - Eggs holder grille
8 - Thermometer
9 - Humidifiers
10 - Adjustment screw and flashing indicator
11 - Separator positioning for the end of hatching
12 - Removing the base grille
1
4
5
7
3
2
RULES AND INSTRUCTION FOR THE CORRECT USE OF THE
AF-25 / AF-50 BROODER
Unpacking and working
For a better packing the cover of the brooder has been turned upside down in
the base.To take the cover off from the base avoid taking it from the protection
grille of the fan andfrom the heating body.
Do not insert any object through the holes of the grille in order to avoid damaging
thecomponents inside the grille.
Take the cover off and check:
• The integrity of the cover
• The integrity of the internal components especially: resistor and fan.
• The integrity of the box with the safety system
• The integrity of the connection wire to the electric network.
• The correct positioning of the waterproofing holes, of the 2-air inlets and the
4 outlets.
If the device is d amaged or one of its compone nts is missing, it is necessary
tosend it back to the distributor o r to an assista nce centre .
IN ANY CASE DO N OT TR Y TO REP AIR IT BY YOURS ELF OR TO MAKE IT WORKING.
QUALIFIED PERSON NEL MUST CARRY OUT EACH REPAIR ONLY.
Inside the base it is lo cated the eggs holder’s sliding grille. The brooder is supplied
withan external knob, which allows moving the grill without opening the brooder.
Note:
In order to allow an easier cleaning of the broo der’s base it is possible to
take awaythe knob and the grille.
To carry out this operation we suggest proceeding as follows:
Press downward with the thumb finger and lift the grille with the other hand as
shownon picture N. 12.
Fig.12
