7.
Consider install location for push button/microphone. Push button
must be within reach and facing driver for voice commands and phone
dialog (cable is 6ft. long).
We recommend completing the rest of the
install prior to securing push button/mic to dashboard.
When
ready to install simply remove tape backing and secure to surface
Fig. 7
Custom installed next to traction button
Ensure no ventilation duct is pointed towards the mic.
It is best to mount button facing driver
USB port installation
An updated “SMART” USB charging port has been added to module which charges
based on device current demands and used for charging only.
(Not for thumb
drives etc.)
A
.
Flush to dash/panel requires drilling a ¾” hole in the dash
B
.
Flush with Support bracket
(use this option to mount USB terminal
wherever your installation demands without drilling)
A.
Flush to Dash or Panel
(drilling required)
1.
Drill a ¾” hole in the dash or panel using a step drill bit or equivalent
(See
Fig. 10
)
Fig. 10
Step drill bit
2.
Insert the 3ft. USB cable male terminal (See
Fig. 11
) through the ¾”
hole created in step 1 and plug into USB port on Module (See
Fig. 11
)
Fig. 11
Flush mount 3 ft. USB cable
