Cosatto 3SIXTI2, Manual

9 - reclining the seat

The backrest has 3 recline positions.

To adjust the seat angle, squeeze the recline handle (a) and recline the seat to desired position, 

release the handle to allow the seat locks into position.

WARNING: Before placing the child into the seat, make sure it is properly secured.

WARNING: Never recline seat whilst the child is seated in highchair.

10 – adjusting seat orientation

The seat can be rotate in 6 orientations.

To adjust simply twist the seat to the required orientation until it clicks into place.

11 - adjusting the seat height

a. To raise the seat height, press the base pedal (a) to allow the seat to raise, release the pedal 

when the seat reaches desired position.

b. To lower the seat height press the base pedal (a) whilst pushing down in the middle of seat. 

Release base pedal before letting go of seat once the seat reaches desired position.

NOTE: When lowering the seat, only press down in the middle of the seat as 

shown in the diagram.

NOTE: The base pedal may be stiff during the initial operations.

WARNING: Never adjust the seat height when child is in the highchair.

12 - detaching the vertical leg from base

The vertical leg can be detached from base for storage purposes.

NOTE: It is recommended to lower the seat to its lowest position prior to 

the detachment in order to achieve maximum compactness for storage and 

reduce the risk of injury while dismantling the product.

1. Place the highchair on its side, pull the trigger (a) underneath the base to release the vertical leg 

from the base unit.

2. Pull the two assemblies apart slowly until they are fully detached.

13 - transporting the highchair

A wheel located at the rear underside of the highchair are used to aid the transportation of the 

highchair.

While standing in front of the highchair, lift the highchair by its seat unit until all friction pads on 

the front of the highchair are off the floor then the highchair can be pull along the ground.