Cosatto NITTY GRITTY NOODLE SUPA, User Manual

operation

1 - list of parts

Your highchair is supplied in one carton and contains:
1. Highchair seat assembly

2. LH leg

3. RH leg

5. Rear foot

6. Screw (x2)

7. Stopper

8.   Inner tray

9.   Outer tray

10. Pommel cover

4. Front foot - The front foot has a red dot sticker at the rear (a).

2 - assembling the highchair - 1

Noting the orientation, fit the legs (2 & 3) to the highchair seat assembly (1) by pushing the legs into the 

seat height adjusters (a & b). 

Press the buttons on each hinge (c) and release the rear legs (d). Push the rear legs outward until the legs lock 

into position (e).

3 - assembling the highchair - 2

Press the button on each seat height adjuster (a) and lift the seat to its highest position (b). The number 1 

should be visible in the height adjuster window (c).

Fit the stoppers (7) with screws (6) to the back of the front legs.

4 - assembling the highchair - 3

Fit the front foot (4) The front foot has a red sticker at the rear. Push in the spring loaded pins (a) on each 

side then fit the ends of the foot into the bottom of the front legs (b) until the spring loaded pins locate in 

the holes in the front legs (c).

Repeat this procedure with the rear foot (5).

5 - raising and lowering the backrest

The backrest has 3 recline positions.

To adjust the position of the backrest, lift the lever at the back of the backrest (a) and raise or lower the 

backrest to the desired position (b). Release the lever. The backrest should then locate into one of the 3 sets 

of slots at the rear of the armrests (c).

6 - adjusting the footrest

The footrest can be set at 3 positions. Press down the buttons (a) on both sides simultaneously then raise or 

lower (b) the footrest to the desired position. Release buttons (a) then move the 

footrest slightly until it locks in position.

7 - adjusting the height of the seat

Press the button on each seat height adjuster (a) to lower the seat (b). Pull the seat height adjusters upwards 

to raise the seat (c). The seat has 6 height positions, position 1 being the highest. The seat height is shown 

in a window in the seat height adjusters (c). Ensure the same seat height number as the same on each side 

of the highchair.

8 - fitting the tray

Pull the lever underneath the tray back (a) then slide the tray (9) into the channels on the sides of the arm-

rests (b). Release the lever them move the tray slightly until it locks in place.

WARNING: Ensure the tray is pushed far enough into the highchair. Numbers on 

top of the armrests show the position of the tray. NEVER use the tray if the symbol 

(       ) is visible.

Check the security of the tray before use by pulling it outwards slightly.

9 - removing the inner tray

To remove the inner tray (8) pull the clips out on both sides (a) then lift the inner tray off the tray (b).

To refit the inner tray place over the tray and push down on the clips until the inner tray locks in place.

Press down at the front and back (c) to secure the centre of the inner tray.