6
35 Lock
nut
2
C7 Spring
washer
Φ
8 2
36 Motor
1
C8 Spring
washer
Φ
4 4
37 Square
Sensor
1
C9
Arc washer
6
38 Transformer
1
C10 Nylon washer
Φ
8
2
39 Driver
1
C11 Nylon
washer
2
40 Safety
key
1 D1 Wrench
1
D2 Screwdriver(S=5)
1 D4 Lubricant
bottle
1
D3 Wrench
(s=6)
1
Assembly Instruction
Please make sure there’s enough space to install the treadmill and recommend 2 persons to
install it.
WARNING: Don’t insert the power wire until the treadmill was fully assembled.
STEP 1.Assemble the upright frame
A: take out the machine from the box; place it on the flat floor; Hold up the computer/handlebar (11) and
the Left & right upright tube (3,4) along with the Computer connecting plate, insert the Computer
connecting plate and the tube of computer/handlebar (11) to the Left & right upright tube (3,4). (NOTE:
Please don’t press against the wires.) (See figure 1-a-b)
STEP 2. Assembling the computer:
A. Connect the front part of Base frame (2) and the upright tube (3,4) with 4 sets of Half-round bolts
M8*16(A13)
，
arc washers
φ
8 (C9) ,Do not tighten the bolts. (See figure 2-A)
B. Connect side part of the Base frame (2) with the upright tube (3,4) by attaching 2 sets of Half-round
bolts M8*45(A9)
，
flat washers
φ
8 (C3) ,still do not tighten the bolts. (See figure 2-A)
C. Connect the computer/handlebar (2) and the upright tube (3,4) by 2 sets of bolts M8*16(A13) and arc
washers
φ
8 (C9) ,. (See figure 2-A)
NOTE: TIGHTEN ALL THE BOLTS ONLY AFTER THEY ARE CONFIRMED TO BE CONNECTED
FULLY AND CORRECTLY,
