Cosco Fitness CMTM-4610A2, User Manual

14

Maintenance and Malfunction Treatment                                    

1)  The surface of the treadmill should be kept 

clean, pull out the power line before 

cleaning. You can clean the running belt 

and the surface of the treadmill with a soft 

and wet cloth. 

2)  The running belt is adjusted at factory; it 

may runs defectively after transportation 

and use. Turn off the treadmill before 

adjusting, pull the belt in the center, and 

then adjust the left and right bolts in rear roller with hex spanner (See figure ) it is 

better to adjust 1/2 circle once. Then turn on the switch, check if the belt           

10 runs defectively when the running speed is 4~5 km/h. 

3)  After using over 100hours or the lubricant between the running board and the 

running belt is used up, please lubricate the running board and adjust the running 

belt well. 

4)  After a long time of running, the belt may be longer and stuck. You should turn the 

left and right adjustor bolt in rear roller clockwise at same position till the runs 

smoothly and freely.