10
c.
Then fix the computer (11) on the top of handlebar support (7). (See figure 5)
6) Attach the Seat cushion
a.
Attach the Seat cushion (20) to the Seat bracket (16) with the three sets of M8 Nylon Nuts (59) and
Φ
8
Flat washers (55). (See figure 6)
b.
Insert the Seat adjustor (16) into the Main frame (4), and then adjust the Seat adjustor (16) to the desired
hole for the appropriate position. Finally, tighten the Spring Knob (27) after adjustment. (See figure 7)
Remark :
When adjust seat cushion (20) ,hold knob fixed seat and screw counterclockwise handle at the
same time, pull the handle after the handle to the end, and the knob axis is also pull to the end. Hold the
handle in your hand, insert the Seat adjustor (16) into the main frame (4). Then adjust the Seat adjustor (16)
to the desired hole for the appropriate position and tighten the Spring Knob (27) after adjustment. (See
figure 7)
7) Attach the Pedals
Tie the two Pedal strips (67) on the left & right Pedals (40), and then
attach the left & right Pedals (40) to the Crank (23). (See figure 8)
NOTE:
The left & right Pedals axis are marked with “
L
” & “
R
”.
Summary of Contents for CEB-TRIM 250U
Page 1: ...Magnetic Upright Bike OWNER S MANUAL CEB TRIM 250U...
Page 7: ...6 4 Overview Drawing...
Page 8: ...7 5 Hardware Packing List...
Page 14: ...13 B23458 C 0801 1400...