10
b. Connect the computer wire (26) to the Sensor wire (25) coming out from mainframe (1) as show on
drawing
D
of figure3.
c. Insert the Front upright frame (14) to the main frame (1) and secure it with six pieces of M8 x 20 Bolts
(38),
Φ
8 Spring washers (51), and
Φ
8 Arc washers (45) as shown on drawing
D
of figure 3.
4). Install the Hand Pulse Bar
a. Insert the hand pulse wires (24) from hand pulse bar (20) into the hole on the back of Front upright
frame (14) and then pull them out from the upper hole of Front upright frame (14).
b. Attach the hand pulse bar (20) to the groove of Front upright frame (14) with two pcs of
Φ
8 arch spacers
(45), and M8 x 16 bolts (93). (Refer figure 4)
5)
.
Install the
Computer
a. Connect the Pulse wires (24) with Sensor wire 2 (26) and put the extra wires into the tube.
b. Attach the Computer (10) to the top of the Front upright frame (14) and tighten with Crosshead bolt M5 x
1
0 (75).
(Refer figure 5)
6). Install the Handlebar Support (Right & Left)
a. Attach one Arc spacers (9) and
Wave washer (28)
to the
right end of horizontal axle of Front upright frame (14).
(make the gouge of the arc face inside)
