53
54
6.
Tighten Tether
Push fi rmly on the
back of the seat and
pull the tether strap
to remove all slack
and create tension
on the strap.
5.
Check Belt
Tightness
Hold child restraint
at the belt path with
your weakest hand.
Push and pull from
side to side.
If it moves more than 1 in. (2.5 cm),
try reinstalling the child restraint or try
another seating location.
Remove the locking clip when the
seat belt is not being used with a
child restraint.
4.
Rebuckle
Vehicle Belt
1.
Determine
Locking Clip
Position
Grasp both
vehicle belts
together just
behind the latch plate to mark the
position for locking clip. Unbuckle
the belt.
NOTE:
If the latch plate ends up just
at the belt path opening so you
cannot grasp the vehicle belt at the
latch plate, grasp the vehicle belts
on the opposite side of the child
restraint, as close to the latch plate
as possible.
2.
Attach
Locking Clip
Thread both
portions of the
vehicle belt onto
the locking clip, as
close to the latch
plate as possible.
3.
Position
Locking Clip
It should be about
1 in. (2.5 cm) from
vehicle belt’s latch
plate.
1 in.
(2.5 cm)