13
Gebruiks- en montagehandleiding cosicube / Operating and assembly instructions cosicube / manuel de montage et mode démploi cosicube
2. Placing the bottle
If you have purchased a gas bottle what is prescribed in the supplied list?). Then you can place the gas bottle in
the Cosicube. However, this is not mandatory. You can also choose to place the gas bottle outside of the unit.
In one of the sides so that there is a hatch, a gas cylinder in the model can be placed. Under the flap is a hook,
go with your hand under the sheet and slide the hook up. Now you can get the cover down and slide out of the
model. Always turn off the gas cylinder on the platform for that purpose. The platform should ensure that the
cylinder is always moved by moving the device along.
-
Installation of the gas bottle extern of the Cosicube
If you want to place the gas bottle outside the Cosicube, for example because you are using a gas bottle
with more capicity than is specified in the list? Then you can use the gas bottle outside the Cosicube,
this has to be done in the following way:
1.
Guide the gashose outside the Cosicube by placing the gashose underneath the model. See
drawing.
2.
The supplied hose is 1.5 m long . Place the gas bottle at a maximum distance of the Cosicube. Be
carefull by placing the gashose, people and pets can stumble over it. Indeed place the cylinder
therefore always at a place where walking along is not possible and where children and pets
cannot reach.
3.
Connect the gasbottle to the supplied pressure regulator and turn the bottle open if you want to
use. When you are not using the Cosicube make sure the gas valve on the gas bottle is turned off.
3. Replacing the cylinder
Is the gas bottle empty and you need to replace it? Make sure the model, ceramic logs and lava rocks are
completely cooled down! Use the definition of point 2 “
placing the
gas bottle” and remove the old bottle. You
can fill up the old bottle at the local gas supplier.
4. Replacing the hose and pressure regulator
Replace your propane gas hose every four years . This is a national advice. Pressure regulators can go for five
years. Always check the unit after replacing the pressure regulator and gas hose for gas leaks .
How to check your Cosicube on gas leaks:
-
Open the gas bottle but do not turn on the Cosicube!
-
Make a spray of half water and half of detergent, and spray this liquid on each connection and the hose.
If there is a gas leak in the connection or the hose there will be air bubbles arise.
-
If bubbles are visible, immediately shut off the gas. Buy a new hose or regulator.
-
If the problem persist, please contact a qualified gas engineer.
