Dust may clog burner pipe and lead to an ignition
failure. Clean it properly with following procedure.
Make sure push button is locked
and battery is removed.
Keep pressing the upper part of
front panel as pulling it forward.
front panel will come off.
Remove the connector on both
sides of burner pipe.
Hold burner pipe firmly and
remove burner pipe by
loosening a hexagon nut on
bottom side of burner pipe with
7mm wrench.
Clean a pinhole as described on
figure, with cotton swabs.
Wash burner pipe with hot water and dry it
completely.
Reassemble burner pipe by inverting the steps 2 to 4.
Cleaning the burner pipe
1.
2.
3.
4.
5.
6.
7.
Gas filling
Make sure push button is locked and battery is
removed.
Set the product upside down before
you inset gas cartridge.
Fill a gas by inset the gas cartridge (for
cigarette lighter) upright to gas inlet on
bottom of the product.
☆
Do not fill a gas in the vicinity of
combustible materials.
☆
Please take the body and a gas cylinder with
your hand when you fill up.
◎
1.
2.
3.
Connector
Burner Pipe
Hexagon Nut
GAS
