7
Bluetooth mode of profiles is active now
5. Get Started
!
Insert/remove the battery
Always switch your product off and disconnect the charger before removing the battery.
When you insert the battery, please align the contacts of batter with the corresponding
connectors on the battery compartment.
!
Insert/Change the SIM card
Before changing the SIM card, please make sure your product is switched off and the
battery is removed.
Make sure that the contact area on the card is facing the connectors on your product and
that the beveled corner is correct with the indicator, then insert the SIM card
!
Charge the battery
"
Please make sure the battery is inserted correctly.
"
Connect the power cord to the device and then connect a compatible charger to a wall
outlet or connect the computer via USB data cable.
"
Your battery has been pre-charged at the factory, but the charging level may vary. To
reach the full operation time, charge the battery until is has been fully charged
according to the battery level indicator.
"
The batter method is to recharge the battery when it runs out, this operation will
continue at least 3 times after you get your mobile phone.
"
If a long time not using your mobile phone, it will take a few minutes to show the
charging animation.
#
WARNING: moving or taking off the battery during charging is forbidden.
6. Telephone
Your mobile phone is a
Dual-card double standby single pass
style. Where
Dual-card
means it supports two SIM cards,
double standby
means all the SIM cards work in standby
mode,
single pass
means only ONE SIM card can answer or make a call, the other is
sleeping at the same time until the call is end.
6.1.
Make a call
$
Important: if keypad of the mobile has been locked, activate the phone function at first
(See Keypad lock)
"
To Make a call, enter the phone numbers (sometimes including the area code when you
