Cee® Apogee™ Developer Manual
Page
5
of
15
1.4. Model and Revisions
The model and serial number information for the Cee® Apogee
™ are located on the rear panel
near the power inlet. Software version information can be found on the About screen. See
DataStream™ Manual for screen shots and a detailed explanation of the system software.
1.5. Safety Hazards/Precautions
Read this manual in its entirety before operating the machine.
1.6. Overview of Equipment-Specific Hazards
The unit is very heavy and proper precautions should be taken when handling the machine to
minimize risk of injury. Labels are placed on the machine to identify areas where caution is
needed during operation.
1.7. Electrical
High voltage is present in the machine. Disconnect the power before servicing.
Stored electrical energy is present in the machine. Before servicing allow sufficient time for
discharge. The servo amp has a charge light; do not service the machine until this light has gone
out.
1.8. Mechanical
This machine uses compressed gasses, which can provide motive force for components and
can expand violently upon decompression. Disconnect N2 or CDA before removing any panels.
The machine is capable of very high-speed rotation. Ensure all lids and panels are in place
before rotating these devices.
Ensure that all panels are on and in their correct locations before powering up or operating.
When opening the lid be aware of the pinch point at the hinge cover. Open the lid only by
using the handle on the lid.
The unit is very heavy and proper precautions should be taken when handling or moving the
machine to minimize risk of injury.