Modello - Modèle - Model EULNSxx
Modell - Modelo - Modelo EULLSxx
STAGE
STATE REVISION
ORD.
A
DATE
05.05.2020
Fabbricante - Constructeur - Manufacturer
Hersteller - Fabricante - Fabricante
Epta Spa - Unità locale:
Via degli Alpini 14 - 32020 Limana
(BL) ITALIA Tel. 0437/9681 Telefax 0437/967434
PAGE:
40/58
N° DOC.
UM000440
ANTIMIST POWER (SV VERSION)
These showcases are equipped with a ventilation system that prevents the formation of mist on
the glazing.
DEFROSTING
The number and duration of defrosts are factory-set.
The user must never alter their adjustment.
Defrost-water is collected by a drain tube and conveyed to an evaporation tray located in the base
of the display cabinet. Periodically check that defrost water flows off normally. Otherwise, unclog
by the use of a pointless flexible probe.
9. PRESCRIPTIONS AND RESTRICTIONS
KEEPING PHARMACEUTICAL PRODUCTS, GLASS BOTTLES OR FLASKS IN THE SHOWCASE IS
STRICTLY FORBIDDEN as they could get broken and entail a safety hazard (fig. 14).
DO NOT REMOVE COVERS OR PANELS WHEN IT REQUIRES THE USE OF TOOLS AND ESPECIALLY
DO NOT REMOVE THE ELECTRIC CONTROL BOARD COVER.
Caution: never remove the glass sliders. The cabinet was designed to only work with the
sliders on.
Do not expose the display case to atmospheric agents (fig.11).
Do not spill water directly or indirectly on the display case (fig. 15).
Do not touch the machine with damp or wet hands or feet; do not use it while barefoot (fig. 17).
Do not step on the bumper rail.
ANY OTHER USE NOT EXPLICITLY MENTIONED IN THIS BOOKLET MUST BE CONSIDERED
AS HAZARDOUS. THE MANUFACTURER DISCLAIMS ALL LIABILITY FOR ANY DAMAGE RE-
SULTING FROM IMPROPER, INCORRECT OR UNREASONABLE USE.
10. ORDINARY MAINTENANCE
ATTENTION! BEFORE MAINTENANCE OR CLEANING, DISCONNECT THE REFRIGERATOR FROM THE
ELECTRICAL POWER SUPPLY USING THE WALL MAIN CUTOFF SWITCH (fig. 20).
IMPORTANT: During maintenance or cleaning operations, be sure that the light in the working area
is sufficient. If necessary, use an additional source of light. Mind also the hot and moving parts
marked with the relevant symbol. The use of heavy-duty gloves is recommended.
CLEANING THE CABINET
1) Every week clean the outer surfaces of the display case with mild soap or detergent in lukewarm
water only. Wipe carefully with a soft cloth. Never clean it using inflammable or scouring agents
alcohol, acetone or solvents.
NEVER CLEAN THE DISPLAY CASE BY THE USE OF WATER JETS (fig. 15). Clean glass surfaces using
glass-cleaning products only. The use of water is not recommended here, as it may cause scale to
build up.
2) Every month clean the cabinet inside surfaces following the instructions provided in the prece-
ding item and those indicated here below:
• Disconnect the cabinet from the power mains by the wall main cutoff switch (fig. 20).
Those who carry out the maintenance work must constantly ensure that the cabinet is
Summary of Contents for STAGE EULLS Series
Page 58: ......
