Part 3 - Configuration
54
•
Line Delimiter
: Designate a string to mark the end of
a line. You can enter control strings by selecting
and then entering ^, followed by a letter. For example,
Carriage Return is ^M and Line Feed (new line) is ^J.
•
Ignore String
: Specify a string to ignore from
transaction records.
•
Case Sensitive
: Ignores case in strings designated
under
Transaction Start
,
Transaction End
,
Line
Delimiter
, and
Ignore String
.
Case Sensitive
does not apply to control strings.
•
Time Out
: Once
Time Out
has been enabled, the
system will assume the end of a transaction if no new
string is entered within the specified duration of time.
Select between 5 secs and 15 mins.
Selecting RS232, RS485, USB-Serial 1 through 8, or LAN 1
through 16 as the port activates the Port Setup button.
Select
Setup
and configure the
Baud Rate
,
Data Bit
,
Stop Bit
, and
Parity
settings.
• If any one of LAN1 through 16 has been selected as
the port, select the Port Setup button and configure
the network port setting.
• If using a USB-serial port, the Text-In feature may
malfunction if the USB cable is removed while the
system is in operation.
•
Title
: Designate a name for the text-in device.
•
Actions
: Specify which actions to take when text-in is
detected.
-
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
-
Alarm-Out
: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
-
Notify
: Configure to be notified of events by Mail,
LAN1 through 5, SNS, and/or Alert Window.
-
PTZ
: Moves the PTZ camera to a specific preset
position when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
Network Setup
Refer to the
for basic
information on using the Setup menus.
General
•
Remote Audio Channel
: Transmits the selected
channel's audio to the remote program. Select
Select
From Client
to stream audio of the channel selected
on the remote program.
Audio skipping and sync issues can occur under poor
network conditions.
•
Enable SSL for Transferring Data
: Applies SSL
(Secure Sockets Layer) protection on remote viewing
and recording data transmissions.
• If using the SSL feature, it will not be possible to
connect to the NVR from a remote program or a
network keyboard that does not support SSL.
• Changing the SSL setting temporarily severs all
remote connections to the NVR in order to apply the
change.
• This product contains content developed by
OpenSSL Project for use in Open SSL Toolkit (http://
www.openssl.org/).
•
WebGuard
: If you wish to use WebGuard, select
WebGuard - Use WebGuard Service
. Select
WebGuard - WebGuard Port and choose a port
number between 12001 and 14000. The port number
can also be entered using the virtual keyboard. For
more information on WebGuard, refer to the
