Costar CR1000INR, User Manual

User’s Manual 

8 

−

 Help Desk

: Choosing the 

OK

 button registers the receiver on the DVRNS server.  Proper DVRNS 

settings will display the help desk information for the DVRNS server.

NOTES:  



  The DVRNS (DVR Name Service) function allows the receiver to use dynamic IP addresses for remote 

connection.  When using this function, you can access the receiver remotely by using the receiver’s 
name instead of its IP address.  For the DVRNS function to

work properly, the receiver should be 

registered on the DVRNS server, and the DVRNS server settings in the INIT program for the receiver 
should match the settings registered on the DVRNS server.  Any changes on the DVRNS server might 
cause improper operation. 



  When LAN settings have been changed, set up the DVRNS settings after saving your LAN changes 

by clicking the 

OK

 button. 



  You will need to get the IP address or domain name of the DVRNS server from your network administrator.  

You can use the domain name instead of IP address if you set up the DNS server during the IP Address 
setup. 



  When using a NAT (Network Address Translation) device, refer to the NAT manufacturer’s instructions 

for the proper network settings. 



  The receiver’s name you entered in the 

DVR Name

 field should be checked by clicking the 

Check

button, otherwise the DVRNS changes will not be saved.  When entering no name or a name already 
registered on the DVRNS server, an error message displays.

Port 



 Admin

: Set up the admin port number for remote 

connection to the receiver. 



 Control

: Set up the port number for remote control using 

a network keyboard. 

NOTE: 

The receiver restarts automatically after changing 

the port setting.

Security 



 SSL

: Check the box to use the SSL function.  You can 

enhance the security of outgoing data from the receiver 
by using the SSL (Secure Sockets Layer) protocol.  
When using the SSL function, the receiver cannot be 
connected with a program or a system that does not 
support the SSL function. 

NOTES:  



  Using the SSL function might cause system congestion 

in the system that receives data from the receiver 
depending on the security level.



  This product includes software developed by the 

OpenSSL Project for use in the OpenSSL Toolkit 
(

http://www.openssl.org/

)