4
1.
2.
3.
4.
5.
INSTALLATION AND SAFETY PRECAUTIONS
LOCATE PURIFIER
NOTE
: If the unit has been on its side for a long period of time,
place the water purifier in the upright position for more than 24-hours
before turning it on.
Place purifier in its upright position.
Locate purifier on a hard and level surface and in a cool shaded
location, near a grounded outlet and main water supply
Plug in power cord.
6. Turn on main water supply and water purifier water valve. (Note: you will
hear water running, this indicates the water reservoir’s are filing.)
7. Turn on Cooling and Heating switches.
Once the water purifier is plumbed and leak free, position the water
purifier so the back and sides are 8”(20 cm) clearance on all sides.
Connect the main water supply to the water cooler, please refer to
“Guidance on Unpacking and Installation” procedure on pages 10
through 12.
1.
2.
ASSEMBLE DRIP TRAY
Assemble the drip tray cover to the drip tray.
Install drip tray and cover onto the lower front door by sliding in until
you hear a click.
ACTIVATE NIGHTLIGHT
Push top side of blue power switch in to turn light on. Push bottom side
in to turn light off.
PLUG INTO A GROUNDED ELECTRICAL OUTLET
Plug power cord into a properly grounded wall outlet.
ACTIVATE HEATING AND COOLING SWITCHES
NOTE
: The water cooler will not dispense hot or cold water until the
switches are turn ON. Do not turn ON switches until water is plumbed
and ready to be used.
To activate the cooling and heating system, turn On the two switches
on the back of the water purifier. See illustration.
Once the switches are activated, both the cooling and heating lights
should turn On.
If you do not want to cool water, keep the switch
in the Off position.
If you do not want to heat water, keep the switch
in the Off position.
