Safety Cautions
The installation of the projector
In order to minimize the times of repair and maintenance, and maintain high-quality images, you
should avoid to install the projector in the tide, dusty and smoke place.In such an environment, then it
must be more frequent to clean the air inlet and the lens,used in such an environment, the projector
will not be shortened service life.
Projector should not to be placed in direct sunlight or where the light is direct shinned indoor
●
The projector screen should not be placed in the sun or indoor light directly. Direct light on the
projector screen will make the image fades and viewing difficult. Using the projector in sunny or
bright indoor, please close the curtains and dim the lights.
Note of the placement of the projector
●
Place the projector on the range of angle to adjust.
Warning about the projector on placing in a high position
●
When the projector is placed in a high position, you must carefully fixed by the projector fall
resulting in personal injury accident.Please unplug the projector's power plug from the outlet,to be
especially careful of the lens, do not touch or damage the lens surface.
Avoid placed where at very high temperatures
●
Operating temperature of the projector
-5
℃～
+35
℃
Storage temperature of the projector is
-10
℃～
+45
℃
Do not block the exhaust and intake vents
●
Left at least 20 cm distance between the exhaust port walls or objects.
●
Please must to
confirm the air inlet and air vents not blocked.
●
If the temperature inside the chassis is a bit high, the protection circuit will automatically cut off
power to the projector, to prevent overheat damage, this does not indicate a fault. Place the projector at
the inlet and exhaust port unobstructed after a few minutes the projector will return to normal
operation.
●
Use the projector remote control or the power button after turning off the cooling fan will continue
running for some time to reduce the internal temperature of the cooling fan stops, then unplug the
power cord
3
