9
Handling Position
Air Outlet
VI.
Handling and Transportation
1. Handle and move the unit
Hold the top of the air outlet window in front panel with one hand and the handle at the top of back panel with
another hand, then move the unit in upright position (As shown in Photo below).
Note:
Do not hold the horizontal louvers by hand.
Make the unit in the upright position whatever handling or moving it.
Drain the water in the unit completely to prevent water leakage and wet the floor or carpet before handling
or moving the unit.
Take away the remote control before handling or moving the unit
图
5
VII.
Installation & Adjustment
Warning:
Keep this mobile air-conditioner in upright position at least 2 hours before first installation.
This air-conditioner may be moved indoors conveniently; keep the unit in upright position while moving it.
The air-conditioner shall be placed on flat surface.
Do not install or operate this air-conditioner in bathroom or other wet environments.
1.1 Installation of exhaust hose assembly and its adapter
1)
Take out the exhaust hose assembly and its adapter from plastic bag.
2)
Extend the exhaust hose at one end, screw the round end of adapter into exhaust hose at anticlockwise
direction
Note: Screw adapter into right position, at least 3 laps, to keep good connection of exhaust hose assembly and
its adapter
1.2 Installation of the exhaust hose assembly into unit
1)
Determine window seal-plate position, vertical or horizontal direction.
2)
If window seal-plate will be in horizontal position, the slant panel A of adapter should be upwards.
